Configuring PAD/ATPAD Ports 9
PAD Port Configuration
Port Speed
Range: 50, 75, 100, 110, 134, 150, 200, 300, 600, 1200, 1800, 2400, 4800,
7200, 9600, 14400, 19200, 28800, 38400, 75/1200, AUTO
Default: 9600
Description: Specifies the port speed in bits per second.
• Port speed is set by this parameter although the PAD Profile
Table can specify a PAD port's characteristics.
• When 134 is selected, the actual speed is 134.5 bps.
• Split speed (75/1200) can be configured only on 6500
PLUS
Processor and Asynchronous I/O Cards.
Auto Baud Sequence
Range: CR_ONLY, CR_DOT_CR, TYMNET, TELENET
Default: CR_ONLY
Description: Specifies the character sequence used for autospeed recognition
for these autospeed ports:
• PAD ports with Port Speed = AUTO
• Device Parity = Auto
• Data Bits Per Character = 7:
– CR_Only: Autospeed on <CR>
– CR_DOT_CR: Autospeed on <CR>.<CR>
– TYMNET: Autospeed on the letter “a” (must be lower
case)
– TELENET: Autospeed on <CR><CR> for 1200 bps or
lower and @ <CR> for 2400 bps or higher
The speeds are supported on all PathBuilder S200 series switches.
The autospeeds of 14.4 Kbps, 19.2 Kbps, 28.8 Kbps, and 38.4
Kbps are not supported on UIO/AIO cards.
• Used to detect and adapt to the speed and parity of a terminal
configured as 7 bit plus parity.
• Select CR_DOT_CR if the connecting terminal's Data Bits
per Character (7 or 8) is unknown or changes
(typical for dial-in applications).
