Configuring PAD/ATPAD Ports 31
PAD Profile Table Record
#5, Device Flow Control
Range: 0 to 2
Default: 0
Description: Specifies if and how the PAD port sending the XON/XOFF
characters restrains the attached terminal from sending data.
• 0: No control with XON/XOFF.
• 1: Control inbound data from device.
• 2: Control inbound data and PAD commands from device.
For DRI control using V.24 connector control signals (CTS), set
this parameter to 0 and use parameter #105, Control Signal
(EIA-232-D) Data Restraint.
Note
Called Data Restraint Inbound (DRI) when using inland control.
#6, Service Signals Control
Range: 0, 1, 4, 5, 9, 12, 13
Default: 5
Description: Controls PAD service signal messages sent to the attached device:
• 0: No service signals sent.
• 1: Service signals, other than the prompt, sent.
• 4: Prompt service signal sent.
• 5: All service signals sent.
• 9: Extended format service signals, other than prompt, sent.
• 12: Extended format prompt service signal sent.
• 13: All service signals sent in extended format.
