Filter
Top Products
preliminary
Installation
22
Modem Setup
The (Modem) icon is displayed when [Modem] is
selected for the serial port usage. When a modem is
connected to the video network station, if the
“Modem” icon does not appear next the “COM2” icon,
refer to “Serial Port Settings” on page 18 to reset the
serial port usage.
1 Click the “Modem” icon.
The “Modem Settings” page appears.
2 Set the necessary items. Settable items are shown
in the table below.
3 Click the “Save” icon to save your settings when
finished.
Setting
Modem Type
Ignore Dial
Tone
Type
Baud Rate
Dial Prefix
Flow Control
Init String
Description
Select the connected modem. If a
matching modem type cannot be
found, select [Generic].
Select [NO] to start connecting after
detecting a dial tone, or select [YES] to
start connecting without a dial tone.
Select [Null] if the modem is connected
with a null-modem (crossed) cable, or
[Autodetected Modem] otherwise.
Select the communication speed
between the serial port and modem.
Select either [Tone Dialing (ATDT)] or
[Pulse Dialing (ATDP)] according to
the type of telephone circuit used for
the modem connection.
Select [CTS/RTS] if flow control is
available, or [OFF] to disable flow
control.
If [Modem Type] is set to [Generic
Modem], enter the required modem
initialization string.
ISP (Internet Service Provider) Setup
The (ISP) icon is displayed when [Modem] is
selected for the serial port usage. The “ISP” icon is
used to set up connection with an “ISP” (Internet
Service Provider). If the “ISP” icon is not displayed,
reset the serial port usage according to “Serial Port
Settings” on page 18.
1 Click the “ISP” icon.
The “ISP Settings” page appears.
2 Set the necessary items. Settable items are shown
in the table below.
3 Click the “Save” icon to save your settings when
finished.
Setting
Select ISP
Phone
Number
Alternative
Number
User Name
Password
Connection
Redial
Attempts
Redial Interval
Description
Select the destination ISP. If a
matching ISP cannot be found, select
[Generic].
Enter the telephone number of the
connection destination.
Enter the alternate telephone number
to be used if connection cannot be
established with the above number.
Enter the user name for ISP host login.
Enter the password.
Select [Always Open] to allow
unlimited connection to the ISP. Select
[Close after] to limit the connection
time, and enter the time limit (in
seconds). To have the ISP connection
cut automatically after transferring
images, select [Optimized].
Enter the number of times to attempt
redialing when a connect attempt fails.
Enter the interval (in seconds)
between redial attempts.