Filter
Top Products
preliminary
Installation
16
The setting items are shown in the following table.
When finished setting, click the “Save” Icon. The
accuracy of the internal clock is ±120 seconds/month
or less.
Changing Passwords and User
Registration
Click the (Security) icon to display the “General
settings – Security” dialog box.
Setting
Date &
Time
Format
Current Camera
Time
New
Camera
Time
Description
Select the display format for date and
time on the monitor screen from the
drop-down list.
Select either [12h] or [24h] for 12- or
24-hour time display.
Displays the current date and time.
The displayed date and time cannot
be edited.
Turn this on to synchronize the video
network station clock with the
computer’s internal clock. The
displayed date and time cannot be
edited.
Turn this on to synchronize the video
network station clock with an NTP
server.
Enter the IP address of the NTP
server.
Select your time zone from the drop-
down list.
Enable this if you need to set the
date and time manually.
Enter the date (yyyy-mm-dd), from
1970-01-01 to 2031-12-31.
Enter the time (hh:mm:ss)
12h/24h
Synchronize
with
computer
time
Synchronize
with NTP
server
IP address
Time Zone
Set
manually
Date
Time
Changing the System Administrator Password
Note
When the video network station is shipped from the
factory, the system administrator’s user name and
password are set to “root” and “pass”. As all units are
programmed with the same settings at shipping time,
you should change the password as soon as possible.
Enter the new administrator’s password in the [Admin
password] field and again in the [Confirm password]
field, then click the “Save” icon. A valid password
consists of up to eight characters, consisting of a-z, A-
Z and 0-9.
Registering a User
With the default setup as shipped from the factory, any
user on the network can access the video network
station. There is no need to register users if access is to
be permitted to anonymous users. However, if access
is to be limited to specific users, register the users by
the following procedure. If more than one user is
registered, video network station connections are
password protected.
1 Enter a user name to be registered in the [User
name] field of the [Add user] item, and enter their
password in the [User password] and [Confirm
password] fields. A user name may be up to ten
characters long, and a password up to eight
characters long, both consisting of a-z, A-Z and
0-9.
2 Place a check in the [HSR Control] checkbox if the
user has permission to control the HSR-1/1P and
HSR-2/2P.
z Hint
The [CTR] button appears in the HSR view to
users for whom this box is checked. Clicking the
[CTR] button accesses the “HSR CONTROL”
page. Refer to “HSR View Mode” on page 33 for
information about controls for HSR View and the
HSR-1/1P/2/2P.
Note
HSR-1/1P/2/2P password-protected functions such
as Key Lock on/off are accessible from the “HSR
CONTROL” page. Access permission to the “HSR
CONTROL” page should be considered very
carefully.
3 Click the “Add” icon.