Filter
Top Products
RX 1510-C/-I/-CI
– 91 –
S
S
Risk of scalding!
Hot hydraulic oil can severely scald the skin at contact.
► Allow machine to cool down before draining the hydraulic oil.
WARNING
1) Park the machine on flat ground.
2) Depressurise the hydraulic system.
3) A threaded plug is located on the right outer side of the rear car
S
for draining
the hydraulic oil. Put an undamaged container with a capacity of at least 45 litres
under the drain hole.
Danger of injury by pressurised hoses!
The hydraulic system is subject to a high pressure during operation.
► Depressurise the hydraulic system before loosening lines or components.
► Never disconnect lines with a running diesel engine.
WARNING
8.9 Hydraulic oil change/ Hydraulic filter change
Maintenance work on the hydraulic system is limited to filters and hydraulic
tanks. All other aggregates do not require maintenance. The hydraulic pipework
should however be examined in regular intervals for leaktightness. Do not spray
hydraulic hoses with paint. The hydraulic oil should likewise changed after larger
repairs on the hydraulic lines. The intake filter
SF
should be replaced after each
hydraulic oil change and every 1000 operating hours. The runback filter cartridge
RF
must be changed after 75 operating hours and regularly every 500 operating
hours at least however once annually. Both filters must be renewed when the
hydraulic oil is exchanged.
NOTE
Never start the engine, if the hydraulic oil has been drained. The hydraulic oil
lubricates the pumps. Without hydraulic oil there is no lubrication and the pumps
are damaged.
Maintaining the machine