Filter
Top Products
RX 1510-C/-I/-CI
– 77 –
7. Loading and transporting the machine
7.1 Safety instructions
7.1.1 General
• Only qualified and appropriately trained specialised personnel, with a minimum
age of 18 years, may participate in loading the machine.
• Persons acting under the influence of drugs, medicines or alcohol may not may
not be involved in loading the machine.
• The maximum total weight of the transport vehicle may not be exceeded.
• The transport lock must be applied before each transport and removed after the
transport.
• Shackles and chock blocks must be always used for fastening the machine.
• The shackles may be attached to the intended transport eyebolts.
• The machine must be fastened in such a way, that it is secured against tilting,
slipping or rolling off, and that no one is endangered by the machine.
7.1.2 Loading the machine with a loading ramp
• If you should not have already made yourself familiar with the control and display
elements of this machine, you must read Section 4. Display and control elements
and thereby make yourself familiar with the functions. All display and control
elements are described there in detail.
• Desist from any method of operation which could pose a safety hazard or impair
the static stability of the machine.
• Check before driving, whether persons or items are in the driving range.
• It is prohibited that persons stay in the vicinity of the articulation, when the engine
is running.
• Is prohibited that persons stay in the area of the loading ramps during the loading
procedure.
• When leaving the workplace, the machine must always be safeguarded against
unintentional rolling away or unauthorised use.
• Loading ramps must be always free of dirt and ice, since they reduce the adhesion of
the drum on the loading ramps. Moisture can also reduce grip on the loading ramp.
• Only use loading ramps with sufficient carrying capacity, stability and width. The
loading ramp inclination may not be steeper, than the maximum climbing ability
of the machine.
• The speed of the machine must be adapted accordingly when driving on the
loading ramp.
• There is lethal danger for persons, if they are in the area of the machine when
supervising the machine and when loading.
7.1.3 Loading the machine with hoisting gear
• The transport protection must be applied before loading with hoisting gear, since front
and rear cars of the machine could otherwise come into contact in the middle.
• Ensure that the carrying capacity of the hoisting gear is sufficient for the weight of
the machine.
• Only hoisting gear with a carrying capacity of at least 2000 kg may be used to
load the machine.
• The machine may only be lifted at the intended transport eyebolts.
• Ensure that there are no loose items on the machine.
• There is a lethal risk for persons, if they step or stand under suspended loads.
• When raised, the machine must not be allowed to swing wildly.
Loading and transporting the machine