Filter
Top Products
RX 1510-C/-I/-CI
– 74 –
F 40 I0
Start Stop
Start Stop
6.1.2 Before operating the machine
Make sure that:
• The fill levels of the operating fluids, hydraulic oil, coolant and engine oil are at
a sufficient level.
• All safety equipment is working.
• All control elements and display elements are working.
• No persons or objects are in the danger zone.
• The transport protection has been released.
6.1.3 Using the vibration function
• Compaction work in direct proximity of buildings can result in damage to buildings
or to lines installed in the ground. Check the effects on buildings and lines. If
necessary, increase the distance between the compaction device and endangered
buildings or stop the compaction work.
• The vibration function of the machine causes the soil in the area of the drum
to vibrate considerably. Persons should not be exposed to these vibrations.
Loose material, such as stones and earth lumps can be hurled through the air.
Persons, who are in the vicinity of the drum can be hit and injured by these flying
around objects. Therefore observe a sufficient safety distance to the machine, in
particular when the vibration function is active.
1) Start the machine with the required control mode or directly at the cockpit with
the ignition key.
2) Drive the machine onto the area to be compacted. Use the fast gear to
overcome larger distances, if the terrain enables this.
3) Switch the fast gear off when you have arrived at the area to the compacted.
Operation: