Filter
Top Products
RX 1510-C/-I/-CI
– 66 –
.
F 40 I0
2
5.3.2 Stand-by mode
The machine reverts to the standby mode, if it is not started within 30 seconds.
The machine can nevertheless be started in this state with one of the control
modes or with the ignition key.
Stand-by : No display active. Only the decimal point
flashes.
NOTE
A low current always flows in the "Standby" mode.The ignition lock serves as
battery disconnection switch.
► In the case of longer work breaks switch ignition off, in order to avoid battery
discharge..
5.3.3 Starting the machine at the ignition lock
Before starting, put the control levers and/or control keys for the vibration function
in the neutral position.
► Turn the ignition key to position "2". The following code is displayed: „F 4010”.
The LEDS for generator and oil pressure drop extinguish. The starter is active,
as long as the ignition key is at the "Ignition position 2".
Starting procedure
Start-up