Filter
Top Products
RX 1510-C/-I/-CI
– 51 –
Start Stop
1
2 3
64
9875
888888
123456
▼▼▼▼▼▼
4.4 Operating elements
Both infrared control and cable control is available for the machine. According
to the machine version it is equipped with one or both of these control methods.
Retrofitting one of these control methods is possible without problems. Different
operating equipment is required for the control methods.
4.4.1 Manual control device
The manual control is used to operate the machine with cable control.
Code numbers are indicated from position 3 to 6.
• Four-digit code numbers are displayed in combination with "F" (function) which
respectively stand for a driving or vibration function. The code numbers for "F"
(function) and their meaning can be found on page 52.
• Four-digit code numbers are displayed in combination with "E" (error/special),
which respectively stand for a function error. The code numbers for "E" (error)
are the same as for the functions.
• 1 or 2-digit code numbers are displayed (position 5 to 6) in combination with "Err"
or "FErr" (error/special), which each stand for an error. The code numbers for
"Err" or "FErr" (error/special) and their meaning can be found on page 98-99.
• 1-, 2-, or 4-digit code numbers are displayed In combination with "S" (Starting
function), dependent on the position of the ignition start switch and/or the
starting programme.
Pos Function
1
Fast gear on/off
2
Driving forward
3
Steering angle left
4
Vibration forward
5
Driving backwards
6
Steering angle right
7
Vibration reverse
8
Start
9
Machine off
Display and operating elements: