Filter
Top Products
RX 1510-C/-I/-CI
– 48 –
888888
888888
• Coolant temperature warning lamp:
Lights up, if the coolant temperature of the motor is too high. The stop sequence
is activated after the LED has been illuminated for 4 seconds. The machine is
shutdown. Possible cause: The cooling water level is possibly too low and cooling
water must be refilled ► See page 89, Section 9.13 Checking cooling water level.
Contact the service workshop for other causes than lack of cooling water.
• Oil pressure control light:
Lights up, if the engine oil pressure drops. The stop sequence is activated
after the LED has been illuminated for 4 seconds. The machine is shutdown.
The machine can only be moved again, after the cause of the emergency stop
has been eliminated. Possible cause: Normally, the engine oil fill quantity is
insufficient and engine oil be refilled See page 84 Section 8.3 Checking engine
oil level. Contact the service workshop for other causes than lack of oil.
4.2 Warning signals
All warning lights light up when switching the ignition on. Troubleshooting is
necessary, if one of the warning lights does not light up. If the cause is a defective
warning light, this only affects machine safety in as far as a defect will not be
indicated by the machine controller and therefore not immediately recognised by
the operator. The warning lights extinguish after starting the engine, if there is no
malfunction.
• Charging control light:
Lights up, if the alternator does not generate voltage. The stop sequence is activated
after the LED has been illuminated for 4 seconds. The machine is shutdown.
Possible cause: Defective alternator. ► Contact service workshop.
Display and operating elements: