Filter
Top Products
Part No. 1110550 51 Tracer® SX5
Section 11 - Options includes the following:
Installing the Amputee Bracket Installing the Crutch and Cane Carrier
Installing the Seat Positioning Strap Installing the Telescoping I.V. Rod
NOTE: The procedures in this section of the manual refer to NON-RECLINER wheelchairs, EXCEPT
INSTALLING THE SEAT POSITIONING STRAP.
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may occur.
INSTALLING THE AMPUTEE BRACKET (FIGURE 1)
1. Refer to the following chart or FIGURE 1 to determine the mounting position of the
amputee bracket:
2. Install the amputee bracket on the wheelchair frame to the position determined in STEP 1.
NOTE: Make sure the axle spacer is located to the outside of the wheelchair.
3. Install the two (2) hex screws and locknuts that secure the amputee bracket to the
wheelchair.
4. Install the rear wheels onto the wheelchair. Refer to REMOVING/INSTALLING THE
REAR WHEELS in SECTION 6 of this manual.
OPTIONS SECTION 11
OPTIONS
FIGURE 1 - INSTALLING THE AMPUTEE BRACKET
REAR VIEW OF
AMPUTEE BRACKET
Axle Spacer Towards OUTSIDE
of Wheelchair
RIGHT
LEFT
Axle Spacer Towards OUTSIDE
of Wheelchair
BRACKET "A" BRACKET "B"
Locknuts
ADULT
RIGHT
ADULT
LEFT
HEMI LEFT
HEMI RIGHT
Hex Screws
SEAT- *BRACKET AXLE SPACER SIDE OF AXLE MOUNTING
TO-FLOOR POSITION WHEELCHAIR POSITION
(on bracket) (on wheelchair)
ADULT A DOWN RIGHT TOP
ADULT B DOWN LEFT TOP
HEMI B UP RIGHT BOTTOM
HEMI A UP LEFT BOTTOM
*"A" and "B" are stamped on the sides of the amputee bracket.