Filter
Top Products
Part No. 1110550 37 Tracer® SX5
Section 7 - Front Casters includes the following:
Installing/Replacing Fork Assemblies
Adjusting Forks
Replacing Front Casters
Replacing/Repairing Front Caster Tire/Tube
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage may
occur.
INSTALLING/REPLACING FORK ASSEMBLIES (FIGURE 1)
WARNING
If converting from six-inch fork to
an eight-inch fork or vice versa,
there are SEAT-TO-FLOOR height
adjustments that must be made. A
qualified technician MUST perform
these adjustments if this is the case.
Make sure both fork/caster assem-
blies are the same size BEFORE
using the wheelchair, otherwise
injury may occur.
NON-RECLINER 20-22 WIDE (300
LB. WEIGHT LIMITATION)
WHEELCHAIRS AND ALL RE-
CLINER MODELS ONLY: The
factory installed 8-inch fork assem-
bly (part number 1089103) and fork
stem washer (part number
1089102), MUST be used on wheel-
chairs of these widths. DO NOT
replace with any other size/style
fork assembly. Otherwise, injury or
damage may occur.
NOTE: This procedure can be performed if re-
placing the exact same size front caster.
FRONT CASTERS SECTION 7
FRONT CASTERS
FIGURE 1 - INSTALLING/
REPLACING FORK ASSEMBLIES
Locknut
Dust Cover
Fork Assembly
Nylon Washer
Caster Headtube
NON-RECLINER WHEELCHAIRS
UNDER 20-INCHES WIDE
NON-RECLINER WHEELCHAIRS
20 TO 22-INCHES WIDE AND
RECLINER MODELS
Locknut
Dust Cover
Fork Assembly
Nylon Washer
Caster Headtube
Fork Stem Washer