Filter
Top Products
Part No. 1110550 23 Tracer® SX5
FRONT RIGGINGS
FRONT RIGGINGS
Section 3 - Front Riggings includes the following:
Installing/Removing the Footrest
Footrest Height Adjustment
Heel Loop Replacement
Elevating Legrest Assembly Installation
Adjusting the Elevating Legrest Assembly
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may occur.
INSTALLING/REMOVING THE FOOTREST (FIGURE 1)
NOTE: This procedure applies to the swingaway footrest and the elevating legrest.
INSTALLING
1. Turn the swingaway footrest assembly
to the side (open footplate is perpen-
dicular to wheelchair).
2. Install the hinge plates on the swing-
away footrest assembly onto the hinge
pins on the wheelchair frame.
3. Push the swingaway footrest assembly
towards the inside of the wheelchair
until it locks into place.
NOTE: The footplate will be on the inside of
the wheelchair when locked in place.
4. Repeat this procedure for the other
footrest assembly.
5. To release the footrest, push the footrest release lever inward, rotate footrest
outward.
REMOVING
1. Push the footrest release lever inward
2. Rotate swingaway footrest assembly outward.
3. Lift the swingaway footrest assembly off of the hinge pins.
SECTION 3
FIGURE 1 - INSTALLING/REMOVING
THE SWINGAWAY FOOTREST
Hinge Pins
Swingaway
Footrest
Assembly
Hinge
Plates
Footrest Release Lever
Footplate
NOTE: Swingaway footrest shown.