Filter
Top Products
Part No. 1110550 21 Tracer® SX5
TROUBLESHOOTING
MAINTENANCE
MAINTENANCE SAFETY PRECAUTIONSMAINTENANCE SAFETY PRECAUTIONS
MAINTENANCE SAFETY PRECAUTIONSMAINTENANCE SAFETY PRECAUTIONS
MAINTENANCE SAFETY PRECAUTIONS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attachment hardware is tightened securely - otherwise, injury or damage
may result.
CAUTION
DO NOT overtighten hardware attaching to the frame. This could cause
damage to the frame tubing.
SUGGESTED MAINTENANCE PROCEDURES
1. Before using your Tracer SX5 or SX5 Recliner wheelchair, make sure all nuts and bolts
are tight. Check all parts for damage or wear and replace. Check all parts for proper
adjustment.
2. Keep quick-release axles free of dirt and lint to ensure positive locking and proper
operation. Refer to ADJUSTING THE QUICK-RELEASE AXLE in SECTION 6 of this
manual.
WARNING
DO NOT use WD-40
®
, 3-in-1 oil
®
, or other penetrating lubricants on quick-
release axles. Otherwise, binding and/or damage to the wheelchair may occur.
3. Clean/oil quick-release axles once (1) a week with a Teflon
lubricant.
WARNING
DO NOT use the wheelchair unless it has the proper tire pressure (p.s.i.).
DO NOT overinflate the tires. Failure to follow these instructions may
cause the tire to explode and cause bodily harm.
4. If tires are pneumatic, recommended tire pressure is listed on the sidewall of the
tire.
SECTION 2
SAFETY INSPECTION
SAFETY INSPECTION
Chair Chair Sluggish Squeaks
Veers 3 Turn or Caster and Looseness
Right/Left Wheels Performance Flutter Rattles in Chair SOLUTIONS
X X X X If pneumatic, check tires for
correct and equal pressure.
X X X X X Check for loose stem nuts and
bolts.