Filter
Top Products
Tracer® SX5 30 Part No. 1110550
SEAT AND BACKSECTION 5
SEAT AND BACK
Seat Extension
Spacer
Phillips Screws
Seat Upholstery
Plug Button
Seat Extension Tube
Crossbrace
FIGURE 4 - ADJUSTING SEAT DEPTH
ADJUSTING SEAT DEPTH (FIGURE 4)
WARNING
The seat depth, size/position of the front casters, size/position of the rear
wheels, use of an anti-tipper model, as well as the user condition directly
relate to the stability of the wheelchair. Any change to one (1) or any
combination of the seven (7) may cause the wheelchair to decrease in
stability. These adjustments MUST be performed by a qualified techni-
cian.
1. Remove the existing seat upholstery from the wheelchair. Refer to REPLACING
SEAT UPHOLSTERY in this section of the manual.
NOTE: If adjusting the seat depth of the wheelchair, the seat upholstery MUST be changed as
well.
2. Remove the two (2) plug buttons from the ends of the crossbraces that are towards
the front of the wheelchair.
NOTE: The two (2) plug buttons will be used in the ends of the seat extensions.
3. Install the two (2) seat extension tubes into the ends on the crossbraces. Line up the
rear mounting hole of the seat extension tube with the second mounting hole from
the end of the crossbrace.
4. Install the two (2) seat extension spacers onto the two (2) seat extension tubes.
5. Install the new seat upholstery onto the wheelchair. Make sure to line up the
mounting holes in the seat extension tubes and seat extension spacers with the new
seat upholstery. Refer to REPLACING SEAT UPHOLSTERY in this section of the
manual.
6. Install plug buttons into the ends of the seat extension spacers.
REAR Mounting Hole
SECOND Mounting Hole From End