Filter
Top Products
Tracer® SX5 28 Part No. 1110550
SEAT AND BACKSECTION 5
SEAT AND BACK
Section 5 - Seat and Back includes the following:
Installing the Back Canes
Replacing Back Upholstery
Replacing Seat Upholstery
Adjusting Seat Depth
Adjusting Seat Width
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may occur.
INSTALLING THE BACK CANES (FIGURE 1)
1. Remove the hex screw and locknut from the bottom of one (1) back cane.
2. Position threaded insert into the bottom of each back cane with nut facing the
outside of the wheelchair and aligned with the mounting hole in the bottom of the
back cane.
3. Insert the back cane into the a mounting hole in the wheelchair frame.
4. Position the hex screw through the wheelchair frame, back cane, and threaded
insert as shown in FIGURE 1.
NOTE: The hex screw should be inserted from the INSIDE of the wheelchair frame.
5. Torque the hex screw to 60-80-inch pounds.
6. Install the locknut onto the hex screw. Secure the hex screw to prevent it from
backing out and torque the locknut to 60-80-inch pounds.
Back Cane
Wheelchair Frame
Locknut
FIGURE 1 - INSTALLING THE BACK CANE TO THE WHEELCHAIR
Hex Screw
Threaded Insert
Nut
OUTSIDE OF
WHEELCHAIR
INSIDE OF
WHEELCHAIR