Filter
Top Products
Part No. 1110550 33 Tracer® SX5
Section 6 - Rear Wheels includes the following:
Removing/Installing the Rear Wheels
Adjusting the Quick-Release Axle
Replacing Rear Wheel Handrim
Replacing/Repairing Rear Wheel Tire/Tube
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage may
occur.
REMOVING/INSTALLING THE REAR WHEELS
NOTE: This procedure applies to NON-RECLINER models ONLY. For RECLINER models, refer to
SECTION 10 of this manual.
WARNING
If changing the size of the rear wheel or a change in the SEAT-TO-
FLOOR HEIGHT is desired, this procedure MUST be performed by a
qualified technician.
Make sure both rear wheels are the same size and are installed into the
same respective mounting hole BEFORE using the wheelchair, otherwise
injury may occur.
PERMANENT AXLES (FIGURE 1)
NOTE: If replacing the same size rear wheel, note the mounting position on the wheelchair frame
for proper reinstallation of the NEW rear wheel.
1. Remove the dust cap, hex screw, spacer and locknut that secure the rear wheel to
the wheelchair frame.
2. Repeat STEP 1 for the opposite rear wheel.
3. To reinstall the rear wheel(s) onto the wheelchair, reverse STEPS 1-2.
4. Adjust wheel locks. Refer to WHEEL LOCK ADJUSTMENT in SECTION 8 of this
manual.
REAR WHEELS SECTION 6
REAR WHEELS
FIGURE 1 - REMOVING/INSTALLING THE REAR WHEELS -
PERMANENT AXLES
Locknut
Dust Cap
Axle Mounting Hole
Rear Wheel
Hex Screw
Spacer
Wheelchair
Frame