Filter
Top Products
Tracer® SX5 40 Part No. 1110550
Section 8 - Anti-tippers/Wheel Locks includes the following:
Installing/Adjusting the Anti-Tippers
Wheel Lock Adjustment
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may occur.
INSTALLING/ADJUSTING THE ANTI-TIPPERS
WARNING
Anti-tippers are specific to the different seat-to-floor angles and/or seat-
to-floor heights. Refer to the chart in this section of the manual for cor-
rect usage and adjustment. If these requirements CANNOT be achieved,
DO NOT use the wheelchair. Contact a qualified technician. Any changes
to the seat-to-floor angle or seat-to-floor height may require different
anti-tippers.
NON-RECLINERS ONLY: If so equipped, anti-tippers MUST be attached
at all times. Inasmuch as the anti-tippers are an option for this wheelchair
(You may order with or without the anti-tippers), Invacare strongly recom-
mends ordering the anti-tippers as a safeguard for the wheelchair user.
RECLINERS ONLY: Anti-tippers MUST BE attached at all times.
Anti-tippers MUST be fully engaged and release buttons fully protruding
out of adjustment holes.
Ensure both anti-tippers are adjusted to the same mounting hole.
INSTALLING THE ANTI-TIPPERS (FIGURES 1 AND 2)
NOTE: To ensure the correct model anti-tipper is used refer to FIGURE 1. Measurements for anti-
tippers are approximate and are taken with extension tube in BOTTOM hole position.
ANTI-TIPPERS/WHEEL LOCKSSECTION 8
ANTI-TIPPERS/WHEEL LOCKS
FIGURE 1 - ANTI-TIPPER LENGTH
Wheelchair Seat-to-Floor Height Anti-tipper (measurements in inches)
Model in inches Length Height Model Part Number
Tracer SX5 17-1/2 to 19-1/2 13-1/2 3-1/4 1360 1058836
Tracer SX5 15-1/2 to 17-1/2 11-5/8 2-3/4 1360A 1058752
Tracer SX5 Recliner 17-1/2 to 19-1/2 13-1/2 3-1/2 N/A 1088242
Flat Surface
Anti-Tipper Height
Bottom Position
Anti-Tipper Length