Filter
Top Products
Part No. 1110550 49 Tracer® SX5
SECTION 10RECLINER
RECLINER
REMOVING/INSTALLING THE SPREADER BAR (FIGURE 4)
WARNING
Make sure both release buttons of the spreader bar fully protrude out
through the holes in the handle BEFORE using the wheelchair.
REMOVING
1. Push in release button on one side of
existing spreader bar.
2. While holding spreader bar, pull the
lock tube until the release button is out
of the handle of the back cane.
3. Drop the spreader bar to one side.
4. Repeat STEPS 1-2 on opposite end of
spreader bar.
INSTALLING
1. Push in release button on one of the lock
tubes of the new/existing spreader bar.
2. Insert lock tube into the handle of the back cane.
3. Ensure the release button fully protrudes out of the hole in the back cane handle.
4. Repeat STEPS 1-3 on opposite end of spreader bar.
REMOVING AND INSTALLING ARMREST (FIGURE 5)
WARNING
Make sure the armrest is securely
locked BEFORE using the wheelchair.
REMOVING ARMREST
1. Unlock the rear armrest by rotating the
armrest release lever towards the outside
of the wheelchair.
1. Press IN the armrest release buttons at the
front of the armrest.
2. While pressing in the armrest release
button, remove the armrest from the arm
sockets by pulling straight up.
INSTALLING ARMREST
NOTE: Rear armrest release lever must be in the unlocked position when installing the armrest.
1. Position the armrest just above the front and rear arm sockets.
2. Push arm down evenly at the front and rear until the front armrest release button snaps into
the front arm socket.
3. Lock rear armrest by turning the armrest release lever towards the back of the wheelchair.
4. Ensure armrest is locked securely in the arm sockets by gently lifting up. If not locked, repeat
STEPS 1-3.
Release Button
Spreader Bar
FIGURE 4 - REMOVING/
INSTALLING THE SPREADER BAR
Handle
Back Cane
Lock Tube
Armrest
Release
Button
Arm Socket
Arm Socket
FIGURE 5 - REMOVING OR
REPLACING ARMREST
Armrest
Armrest
Release
Lever