Filter
Top Products
Part No. 1110550 35 Tracer® SX5
ADJUSTING THE QUICK-RELEASE AXLE (FIGURE 3)
NOTE: Quick-release axles are available on Non-Recliner wheelchairs ONLY.
1. Remove rear wheel and quick-release axle fromthe wheelchair. Refer to REMOV-
ING/INSTALLING THE REAR WHEELS in this section of the manual.
2. Depress detent pin in the quick-release axle and slide axle through the rear wheel hub.
3. Release detent pin ensuring that the locking pins are fully released.
4. Increase or decrease end play by adjusting the locknut on the end of the quick-release
axle.
5. Reinstall rear wheel onto the wheelchair. Refer to REMOVING/INSTALLING THE
REAR WHEELS in this section of the manual.
Detent Pin
Locknut
Locking Pins
Rear
Wheel
Hub
Quick- Release Axle
Axle Spacer
(Conventional
Arms Only)
Wheelchair Frame
FIGURE 3 - ADJUSTING THE QUICK-RELEASE AXLE
SECTION 6REAR WHEELS
REAR WHEELS