Filter
Top Products
SECTION 13—ACCESSORIES
Part No 1125085 77 Pronto® M51™and M61™with SureStep®
Installing/Removing the Oxygen Holder
ƽ WARNING
Contact your oxygen supplier for instructions in the use of oxygen. Extreme care
MUST be exercised when using oxygen in close proximity to electric circuits.
The Invacare oxygen holder is designed to be used in conjunction with oxygen
cylinder models MD15 and ME24 only.
To maintain safety, use only Invacare oxygen cylinder accessories (i.e. regulator,
oxygen demand devices).
DO NOT use the oxygen holder for anything other than its intended purpose of
supporting an oxygen cylinder - otherwise, injury or damage may occur.
DO NOT attempt to modify the oxygen holder to fit any other type of wheelchair.
The oxygen holder was designed specifically for Invacare wheelchairs only.
The installation of the oxygen holder onto the back of the wheelchair seat
significantly increases the length of the wheelchair. When turning the wheelchair it
is important to take note of this increased length - otherwise, injury or damage may
occur.
When using nasal or masked type administering equipment, oxygen or air tubing
MUST be routed and secured properly to ensure that the tubing does not become
entangled, kinked or severed. If necessary, loosen but DO NOT remove the mount-
ing knob.
NOTE:Forthisprocedure,referto
FIGURE 13.2.
NOTE:Reversethefollowingprocedureto
removetheoxygenholder.
NOTE:TheO
2
holderassemblycanbe
mountedontheRIGHTorLEFTsideofthe
seatback.Determinetheappropriatesideprior
toinstallation.
1. Removethetopandbottommounting
screwsandwasherssecuringtheupper
hingetotheseat.Retainscrewsto
installtheO
2
holder.
2. AligntheO
2
holdermountingholes
withthemountingholesintheupper
hingeandseatbackasshownin
FIGURE 13.2.
3. Usingthetwomountingscrewsand
washersremovedinSTEP1,securethe
O
2
holdertotheupperhingeandseat
back.Securelytighten.
FIGURE 13.2 Installing/Removing the
Oxygen Holder
Top
Mounting
Screw
Flat
Washer
Flat Washer
O
2
Holder
Right
Side
Seat
Back
O
2
Cylinder
Upper
Hinge
Bottom
Mounting Screw
Left
Side