Support User Manuals

Invacare Pronto M61 Mobility Aid User Manual

Open as PDF

of 80

SECTION 9—FRONT RIGGINGS

Part No 1125085 53 Pronto® M51™and M61™with SureStep®

Standard Seat

NOTE:Forthisprocedure,refertoFIGURE 9.7onpage 54.

NOTE:Whenadjustingthetelescopingfrontriggingsupportdepth,ensurethefootplatedoesnot

interferewiththecasterwheelrotation.

NOTE:Telescopingfrontriggingsupportsmaybeextendedupto2‐inchesfromthewheelchair

framein1‐inchincrements.Thisadjustmentdoesnotaffectseatdepth.

NOTE:Wheninstallingthefrontriggingssupporttubes,ensurethatthehingepinsareonthe

outsideofthechairfacingawayfromtheseatframe.

1. Removetheseat.RefertoRemoving/InstallingtheSeatAssembly

onpage 35.

2. Removethetwosocketboltsandlocknutsthatsecuretelescopingfrontrigging

supporttotheseatframe.

3. Performoneofthefollowing:

•Adjusting‐Aligntheappropriatemountingholeofthetelescopingfrontrigging

supportwiththefrontmountingholeintheseatframetubestoachievethedesired

depthas

showninFIGURE 9.7.

•Replacing‐

i. Removetheexistingtelescopingfrontriggingsupportfromthewheelchair

frame.

ii. Insertthenewtelescopingfrontriggingsupportintotheseatframe.

iii. Aligntheappropriatemountingholeofthetelescopingfrontriggingsupport

withthefrontmountingholeintheseatframetubestoachievethedesired

depthasshowninFIGURE 9.7.

NOTE:Thefootplatewillbeontheinsideofthewheelchairwhenlockedinplace.

4. Usingthetwosocketboltsandlocknuts,securethetelescopingfrontriggingsupport

totheseatframeasshowninFIGURE 9.7.

5. Ifnecessary,repeatSTEPS2‐4onremainingtelescopingfrontriggingsupport.

6. Reinstalltheseat.RefertoRemoving/InstallingtheSeatAssemblyonpage 35.

previous next