Support User Manuals

Invacare Pronto M61 Mobility Aid User Manual

Open as PDF

of 80

SECTION 9—FRONT RIGGINGS

Pronto® M51™and M61™with SureStep® 50 Part No 1125085

Model PH904A and PHAL4A

NOTE:Forthisprocedure,refertoFIGURE 9.3.

NOTE:PH904Astylefrontriggingshown.PHAL4Afrontriggingadjustthesameway.

1. Loosen,butdonotremovethelugbolt

andlocknutthatsecurethelower

footresttothefootrestsupport.

2. Repositionthelowerfootresttothe

desiredheight.

3. Securelytightenthelugboltand



locknutthatsecurethelowerfootrestto

thefootrestsupport.

4. RepeatSTEPS1‐3fortheoppositeside

ofthewheelchairfootrest,ifnecessary.

FIGURE 9.3 Adjusting Footrest Height -

Model PH904A and PHAL4A

Replacing Heel Loops

NOTE:Forthisprocedure,refertoFIGURE 9.4.

1. Notethepositionofhexbolt,coved

washersandlocknutforreinstallation.

2. Removethehexbolt,covedwashers

andlocknutthatsecurethelower

footresttothefootrestsupport.

3. Removethelowerfootrest.

4. Removethephillipsbolt,spacerand

locknutthatsecuretheexistingheel

looptothelowerfootrest.

5. Slidetheexistingheelloopoffthe

lowerfootrest.

6. Replaceheelloop.

7. ReverseSTEPS1‐6toreassemble.

FIGURE 9.4 Replacing Heel Loops

NOTE:Whensecuringheellooptolowerfootrest,tightenthephillipsscrewandlocknut untilthe

spacerissecure.

Locknut

Footrest

Support

Lower

Footrest

Lug Bolt

Coved

Washer

Hex Bolt

Footrest

Support

Coved

Washer

Locknut

Lower

Footrest

Phillips

Bolt

Locknut

Spacer

Heel Loop

Locknut

previous next