Support User Manuals

Invacare Pronto M61 Mobility Aid User Manual

Open as PDF

of 80

SECTION 9—FRONT RIGGINGS

Part No 1125085 49 Pronto® M51™and M61™with SureStep®

Removing

1. Pushthefrontriggingreleaseleverinwardandrotatethefootrestout.

2. Liftuponfrontriggingandremovefromthewheelchair.

3. RepeatSTEPS1‐2foroppositesideofwheelchair.

Adjusting Footrest Height

Model PHWH93

NOTE:Forthisprocedure,refertoFIGURE 9.2.

1. Removeanyaccessoriesfromthefootrest(s).

2. Removethefootrestfromthewheelchair.RefertoInstalling/RemovingFrontRiggings

onpage 48.

NOTE:Layfootrestonaflatsurfacetosimplifysection.

3. Removethehexbolt,covedwashersandlocknutthatsecurethelowerfootresttothe

footrestsupport.

4. Repositionthelowerfootresttothedesiredheight.

5. Reinstallhexbolt,covedwashersandlocknutthatsecurelowerfootresttofootrest

support.Tightensecurely.

6. RepeatSTEPS1‐5fortheoppositesideofthewheelchairfootrest,ifnecessary.

7. Reinstallthefootrest(s)ontothewheelchair.RefertoInstalling/RemovingFront

Riggingsonpage 48.

8. Reinstallanyaccessoriesontothefootrest(s).

FIGURE 9.2 Adjusting Footrest Height - Model PHWH93

Coved Washer

Hex Bolt

Footrest Support

Coved Washer

Locknut

Lower Footrest

previous next