Support User Manuals

Invacare 9000 SL Mobility Scooter User Manual

Open as PDF

of 88

SECTION 7—RECLINER

Part No. 1076155 65 9000 Series

Replacing Locking Rod

NOTE:Forthisprocedure,refertoFIGURE 7.6.

1. Removethemountingscrewandlocknutthatsecurethelockingrodtothebacktube

mountingbracket.

2. Pulllockingrod/reclinertubeassemblybackward.

3. Removeanti‐rattlefromlockingrod.

4. Whileholdingthelockingrod,squeezereleasehandle.

NOTE:Bysqueezingthereleasehandleandactivatingthereclinemechanism,thelockingrodis

released.

5. Pullexistinglockingrodoutofreclinertubeassembly.

6. Installnewlockingrodintothereclinertube.

7. Slideanti‐rattledownnewlockingrodandpositionontopofthereclinertube

assembly.

8. Pushlockingrod/reclinertubeassemblyforward.

9. Whilesqueezingthereleasehandle,aligntheholesofthelockingrodwiththeholes

inthebacktubemountingbracket.

10. Securethenewlockingrodtothebacktubemountingbracketwithexistingmounting

screwandlocknut.Securelytighten.

FIGURE 7.6 Replacing Locking Rod

Replacing Back Tube

NOTE:Forthisprocedure,refertoFIGURE 7.7.

1. Removethespreaderbar.RefertoStoring/ReplacingtheSpreaderBar

intheownerʹs

manual,partnumber1056953.

Back Tube Mounting

Bracket (STEPS 1,9,10)

Locknut

(STEPS 1,10)

Locking Rod

(STEPS 1,2,4-10)

Anti-Rattle

(STEPS 3,7)

Recliner Tube

(STEPS 2,5,6-8)

Tie-Wraps

(STEPS 4,7)

Mounting Screw

(STEPS 1,10)

previous next