Filter
Top Products
SECTION 5—SEAT TO FLOOR
Part No. 1076155 29 9000 Series
SECTION 5—SEAT TO FLOOR
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise, injury or damage may occur.
Changing Seat-to-Floor Height/Seat-to-Floor Angle
ƽ WARNING
Before performing this procedure, refer to Stability - All Models on page 12 for
additional requirements.
DO NOT deviate from the charts on the following pages. If the restrictions for
seat-to-floor heights and seat-to-floor angles are not followed, the wheelchair will be
in an unsafe position. Before changing these settings, refer to the following charts
for the allowable positions.
NOTE:Forthisprocedure,refertoFIGURE 5.1.
NOTE:Thissectionisfornon‐reclinerwheelchairsonly.Forrecliners,refertoChanging
Seat‐to‐FloorHeightonpage 77.
NOTE:Seat‐to‐floorangleadjustmentsareonlyavailableon9000XTwiththeoffsetaxleoption
andadjustablecasterjournal(ADJC).Allothermodels/optionshavea3°seat‐to‐floorangle.
ThedifferentSeat‐to‐Floorheightsandangles(Detail“A ” ) arepossiblebyusingdifferent
combinationsofrearwheels,rearwheelpositions,frontcasterpositions,frontcastersize
andcampositions.
1. Determinethemodelandframestyleofyourwheelchair.Refertothe followingchart
andFIGURE 5.1.
MODEL FRAME STYLE
Adult/Hemi Adult/Tall Super Low
9000 SL X N/A N/A
9000 XT X N/A X
9000 XT with Bolt-on-Headtube (ADJC) X N/A N/A
9000 XDT N/A X N/A