Filter
Top Products
SECTION 3—SEAT AND BACK
9000 Series 18 Part No. 1076155
SECTION 3—SEAT AND BACK
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise, injury or damage may occur.
The seat depth, back height/angle, seat angle, size/position of the front casters,
size/position of the rear wheels, anti-tipper model, as well as the user condition
directly relate to the stability of the wheelchair. Any change to one (1) or any
combination of the ten (10) may cause the wheelchair to decrease in stability. Use
extreme caution when using a new seating position.
Adjusting Back Angle
NOTE:Forthisprocedure,refertoFIGURE
3.1.
NOTE:Thisprocedureappliesto 9000XTand
9000SLadjustablebackmodelwheelchairs
only.
NOTE:SpacesaverarmsDONOTworkwith
theadjustableanglebackoption.
1. Loosen,butDONOTremovethepivot
screwandlocknutthatsecurestheback
anglebrackettothewheelchairframe.
2. Removethehexscrew,washersand
locknutthatsecurethebackangle
brackettothewheelchairframe.
3. Determinethemountingholeinthe
backanglebracketforthenecessary
backanglerelativetotheseatframe.
4. Re‐installthebackanglebrackettothe
wheelchairframewiththe
existinghex
screw,washersandlocknut.Securely
tighten.
5. Securelytightenthepivotscrewand
locknutloosenedinSTEP1.
6. RepeatSTEPS1‐5fortheoppositeside
ofthewheelchair.
NOTE:Ensurebothbackanglebracketsare
adjustedtothesamemountingposition.
FIGURE 3.1 Adjusting Back Angle
105°
85°
95°
Washer
110°
100°
95°
90°
85°
Hex
Screw
Back Angle
Bracket
Wheelchair
Frame
Locknut
Washer
Locknut
Pivot Screw
Back Angle
Bracket
Back Angle
Bracket
Back Angle
Bracket
Back Angle
Bracket
Back Angle
Bracket
Back Angle
Bracket
105°