Support User Manuals

Invacare 9000 SL Mobility Scooter User Manual

Open as PDF

of 88

SECTION 7—RECLINER

Part No. 1076155 61 9000 Series

4. Loosenthejamnut,rotateclockwise(downward)andrunthejamnuttothebottom

ofthethreads.

5. Holdswivelnutinplaceandunthreadcableassemblyfromswivelnut.Tounthread,

rotateclockwise.

NOTE:Forproperinstallationofthenewcableassembly,notethenumberofrevolutionsrequired

forremovingtheexistingcableassembly.

6. Insertthethreadedendofthecableassemblyintotheexistingswivelnut.

7. Holdtheswivelnutandrotatethecableassemblycounterclockwise(upward)the

numberofrevolutionsnotedfromSTEP5(approximatelyten(10)revolutions).

8. Connectthenewlowercableassembly.RefertoDisconnecting/ConnectingLower

CableAssemblyonpage 61.

9. Reinstallreleasehandle.RefertoReplacingReleaseHandle

onpage 58.

10. Securethecabletothebacktubewithnewtiewraps.

FIGURE 7.3 Replacing Cable Assembly

Disconnecting/Connecting Lower Cable Assembly

NOTE:Forthisprocedure,refertoFIGURE 7.4onpage 63.

Disconnecting

1. RemovetheU‐boltandtwo(2)locknutsthatsecurethehousingandsupportplateto

thereclinertube.

Connecting

1. Lubricatethreadsofboththethreadedsectorandthethreadsofthelockingrod

(WD‐40®orequivalent).

Tie Wraps

(STEPS 1,9)

Cable

Assembly

Back Tube

STEPS 2, 7, and 8

Swivel Nut

Jam Nut

Threads

previous next