Support User Manuals

Invacare 9000 SL Mobility Scooter User Manual

Open as PDF

of 88

SECTION 7—RECLINER

Part No. 1076155 59 9000 Series

NOTE:Turningtheswivelnutcounterclockwisewillpullthebarrelendofthecableassembly

downwardcreatingtensiononthereleasehandle.

9. Rotatethejamnutcounterclockwise(upward)directlyunderneaththeswivelnut.

Securelytighten.

NOTE:Allowseven(7)threadstobeexposedbelowthejamnut.SeeDetailʺBʺ.

10. Squeezethereleasehandleandnotetheamountofplay.Ifthereleasehandleistoo

looseortootight,refertoAdjustingCableAssemblyTensiononpage 59.

FIGURE 7.1 Replacing Release Handle

Adjusting Cable Assembly Tension

NOTE:Forthisprocedure,refertoFIGURE 7.2.

NOTE:Activationofthereclinemechanismdependsonpropertensionofthecableassembly.

Propertensionisdefinedasthereleasehandlehavingsomeresistancewhensqueezedandfirmly

heldinplacewhennotactivated.

NOTE:Ifthetensionofthecableassemblyis:

•Too

loose(toomuchplayinreleasehandle)‐Thereclinemechanismwillnotbeactivatedwhen

thereleasehandleissqueezed.

•Tootight(releasehandleneedsmoreplay)‐Thereleasehandlewillbedifficulttosqueeze.

1. Performone(1)ofthefollowing:

Cable

Assembly

Seven (7)

Threads

Back Tube

Mounting

Bracket

DETAIL “B”

Barrel End of

Cable

(STEPS 4,6)

Locknut

(STEPS 3,7)

Back Tube

Release Handle

(STEPS 3,5,7)

Larger Hole

(STEPS 4,6)

Swivel Nut

(STEPS 2, 8, 9)

Jam Nut

(STEPS 1,11)

Cable Assembly

(STEP 4)

Back Tube

Mounting

Bracket

(STEPS 3,7)

Mounting

Screw

(STEPS 3,7)

DETAIL “A”

previous next