Filter
Top Products
SECTION 7—RECLINER
9000 Series 58 Part No. 1076155
SECTION 7—RECLINER
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise, injury or damage may occur.
ALWAYS make sure that the wheelchair is stable before using the recliner option.
Ensure the spreader bar is attached and secured before using the 9000XT Recliner.
Lift Kit Models Only - Both spring lift mechanisms MUST be operational before
using the recliner. DO NOT operate the recliner option if only one (1) of the spring
lift mechanisms is operational.
Replacing Release Handle
NOTE:Forthisprocedure,refertoFIGURE 7.1.
1. Rotatethejamnutclockwiseandrunthejamnutdownwardtothebottomofthe
threads.
2. Turntheswivelnutclockwiseandruntheswivelnutdownwardtothetopofthejam
nut.
NOTE:Turningtheswivelnutclockwisewillpushthebarrelendofthecableupward.
3. Removethemountingscrewandlocknutthatsecurethereleasehandletotheback
tubemountingbracket.
4. Threadthebarrelendofthecableassemblythroughthelargerholeontheexisting
releasehandle.SeeDetailʺAʺ.
5. Removetheexistingreleasehandle.
6. Threadthebarrelendof
thecableassemblythroughthelargerholeonthenewrelease
handle.SeeDetailʺAʺ.
ƽ WARNING
When securing the release handle to the back tube mounting bracket, DO NOT
overtighten the mounting screw. Overtightening the mounting screw will cause the
release handle to jam when squeezed, and the recline mechanism will not
disengage, possibly causing injury to the user and/or assistant or damage to the
equipment.
7. Securethenewreleasehandletothebacktubemountingbracketwiththeexisting
mountingscrewandlocknut.
NOTE:Tightenuntilsnugfit.DONOTovertighten.
8. Rotatetheswivelnutcounterclockwise(upward).