Support User Manuals

Invacare 9000 SL Mobility Scooter User Manual

Open as PDF

of 88

SECTION 6—REAR WHEELS

Part No. 1076155 53 9000 Series

5. Ifthedetentballsarenotprotrudingpasttheinsideoftheaxlebushingorthereistoo

muchside‐to‐sidemovementoftherearwheelassembly,refertotheOwner’sManual

(partnumber1056953)forinstructionsonadjustingthequickreleaseaxle.

FIGURE 6.1 Removing/Installing Rear Wheels - Quick-Release Axles

Permanent Axles

Models without Offset Axle Option

NOTE:Forthisprocedure,refertoFIGURE 6.2.

NOTE:Ifreplacingthesamesizerearwheel,notethemountingpositiononthewheelchairframe

forproperreinstallationofthenewrearwheel.

1. Removethehubcap(ifapplicable),mountingscrewandlocknutthatsecuretherear

wheelandaxlespacer(ifapplicable)tothewheelchair.

NOTE:Axlespacerisusedonlyifwheelchairisequippedwithconventionalarms.

2. Toreinstalltherearwheelontothewheelchair,reverseSTEP1.

3. Torquelocknutto40‐45ft‐lbs.

4. RepeatSTEPS1‐3fortheoppositewheel.

Quick-Release Axle

Detent Pin

Detent Balls

Axle Bushing

DETAIL “A” - DETENT BALLS AND DETENT PIN

Inside of

Wheelchair

Outside of

Wheelchair

Quick-Release Axle

Rear Wheel

Axle Spacer (Conventional Arms Only)

Axle Mounting Positions

Wheelchair Frame

previous next