Support User Manuals

Invacare 9000 SL Mobility Scooter User Manual

Open as PDF

of 88

SECTION 7—RECLINER

9000 Series 64 Part No. 1076155

Replacing Threaded Sector

NOTE:Forthisprocedure,refertoFIGURE 7.5.

1. Disconnectthelowercableassembly.RefertoDisconnecting/ConnectingLowerCable

Assemblyonpage 61.

2. Removethereleasehandle.RefertoReplacingReleaseHandleonpage 58.

3. Removetheexistingthreadedsectorbyperformingthefollowing:

A. Threadthebarrelendofthecablethroughthelargerholeonthethreadedsector.

B. Removeexistingthreadedsectorfromhousing.

4. Installthenewthreadedsector:

A. Threadbarrelendofcableassemblythroughthelargerholeinthenewthreaded

sector.

B. Positionthebarrelendofcableinsmallerholeofnewthreadedsector.

5. Reinstallthereleasehandle.RefertoReplacingReleaseHandleonpage 58.

6. Squeezethereleasehandleandverifythatthecableisactivatingthethreadedsector.

7. Ifreleasehandledoesnotactivatethreadedsector,performthefollowing:

A. Makesurebarrelendofcableispositionedinsmallerholeofnewthreadedsector.

B. Ensurereleasehandleisinstalledproperly,repeatSTEP7.

C. Ifreleasehandlestilldoesnotactivatethreadedsector,contactInvacaretechnical

supportatthenumberlistedonthebackcover.

8. Connectthelowercableassembly.RefertoDisconnecting/ConnectingLowerCable

Assemblyonpage 61.

FIGURE 7.5 Replacing Threaded Sector

Larger Hole

(STEPS 3,4)

Threads

Support Housing

(STEP 3)

Cable Assembly

Smaller Hole

(STEP 4)

Threaded Sector

(STEPS 3,4)

Barrel End of Cable

(STEPS 3,4)

previous next