Filter
Top Products
12 OPTIONS
Part No 1110546 59 Invacare® Tracer™ EX2 Wheelchair
12 Options
12.1 Installing Amputee Bracket
1. Refer to the following chart or FIGURE1 to determine the mounting position of the amputee bracket:
2. Install the amputee bracket on the wheelchair frame to the position determined in STEP 1.
3. Install the two hex screws and locknuts that secure the amputee bracket to the wheelchair.
4. Install the rear wheels onto the wheelchair. Removing/Installing Rear Wheels
on page 44.
ƽ
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur.
For this procedure, refer to FIGURE1 on page 60.
SEAT-TO-FLOOR BRACKET AXLE SPACER POSI-
TION (ON BRACKET)
SIDE OF
WHEELCHAIR
BRACKET MOUNTING POSITION
(ON WHEELCHAIR)
ADULT
ADULT
HEMI
HEMI
A*
B*
B*
A*
DOWN
DOWN
UP
UP
RIGHT
LEFT
RIGHT
LEFT
TOP
TOP
BOTTOM
BOTTOM
* - “A” and "B" are stamped on the sides of the amputee bracket.
Make sure the axle spacer is pointing towards the outside of the wheelchair.