Invacare 1110546 Wheelchair User Manual


 
3 SAFETY
Part No 1110546 11 Invacare® Tracer™ EX2 Wheelchair
Anti-tippers
ƽ
WARNING
Anti-tippers are specific to the different seat-to-floor angles and/or seat-to-floor heights. Refer to the chart in this section of
the manual for correct usage and adjustment. If these requirements cannot be achieved, DO NOT use the wheelchair.
Contact a qualified technician. If changing the seat-to-floor height with or without a change to seat-to-floor angle, the correct
anti-tippers MUST be used to maintain a 1
1
/
2
to 2 inch ground clearance.
If so equipped, anti-tippers MUST be attached at all times. Inasmuch as the anti-tippers are an option for 0° or 3° on this
wheelchair (You may order with or without the anti-tippers), Invacare strongly recommends ordering the anti-tippers as a
safeguard for the wheelchair user.
Anti-tippers MUST be fully engaged and release buttons fully protruding out of adjustment holes.
ALWAYS use anti-tippers. When outdoors on wet, soft ground or on gravel surfaces, anti tippers may not provide the same
level of protection against tip over. Extra caution MUST be observed when traversing such surfaces.
Ensure both anti-tippers are adjusted to the same mounting hole.