Filter
Top Products
8 REAR WHEELS
Part No 1110546 45 Invacare® Tracer™ EX2 Wheelchair
1. Remove the dust cap (SA Frame only), hex screw, washer (SA
Frame only), spacer (if installed) and locknut that secure the rear
wheel to the wheelchair frame.
2. Repeat STEP 1 for the opposite rear wheel if desired.
3. To reinstall the rear wheel(s) onto the wheelchair, reverse STEPS
1-2 and torque locknut to 40 ft.-lbs.
4. Adjust wheel locks. Refer to Using/Adjusting Patient Operated
Wheel Locks on page 54.
FIGURE1 Removing/Installing Rear Wheels - Permanent Axles
Quick-Release Axles
1. Push in the detent pin of quick-release axle (with wheel) and pull the axle out through the opening in the center of the rear wheel and axle spacer.
2. Push in the detent pin of the quick-release axle again and pull the axle out of the rear wheel.
3. Repeat STEPS 1-2 for the opposite rear wheel.
4. To reinstall the rear wheel onto the wheelchair, reverse STEPS 1-3.
The spacer is used on wheelchairs with removable arms
only.
Rear Wheel
Washer
(SA Frame
ONLY)
Dust Cap
(SA Frame
ONLY)
Hex Screw
Spacer (Wheelchairs with
Removable Arms ONLY)
Wheelchair Frame
Locknut
Axle Mounting Axle
If replacing the same size rear wheel, note the mounting position on the wheelchair frame for proper reinstallation of the
new rear wheel.
Axle spacer is used only if wheelchair is equipped with conventional arms.
Make sure axle spacer is between rear wheel and wheelchair frame if wheelchair is equipped with conventional arms.