Filter
Top Products
8 REAR WHEELS
Invacare® Tracer™ EX2 Wheelchair 46 Part No 1110546
5. If the detent balls are not protruding past the inside of the axle bushing or there is too much side-to-side movement of the rear wheel assembly,
refer to Adjusting Quick-Release Axle on page 47.
0
FIGURE2 Removing/Installing Rear Wheels - Quick-Release Axles
ƽ
WARNING
Make sure the detent pin and detent balls of the quick-release axle are fully released before operating the wheelchair.
The detent balls MUST be protruding past the inside of the rear wheel axle bushing for a positive lock (Detail "A").
Keep detent balls clean.
Invacare recommends inserting quick-release axles with the detent pin to the inside of the wheelchair to prevent accidental
release during contact activities.
Quick-Release Axle
Detent
Pin
Detent Balls
Axle Bushing
DETAIL “A” -
DETENT BALLS
AND DETENT PIN
Inside of
Wheelchair
Outside of
Wheelchair
Wheelchair Frame
Axle Mounting Positions
Axle Spacer
(Conventional Arms Only)
Quick-Release
Axle
Rear Wheel