Filter
Top Products
10 ANTI-TIPPERS/WHEEL LOCKS
Part No 1110546 53 Invacare® Tracer™ EX2 Wheelchair
Adjusting the Anti-Tippers
1. Place the wheelchair on a flat surface.
2. Press the release buttons on the wheeled portion of the anti-tipper
and slide it up or down to the desired adjustment hole.
3. Check to make sure that the release buttons are fully engaged in
adjustment holes.
4. Ensure both anti-tippers are adjusted to the same height.
5. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
6. If the distance between the bottom of anti-tipper wheels and the
ground/floor is not 1
1
/
2
to 2 inches, repeat steps 2-5 until the
distance is 1
1
/
2
to 2 inches.
7. If the 1
1
/
2
to 2 inch distance cannot be achieved, a different model
may be required. Contact an Invacare dealer or qualified technician.
FIGURE2 Adjusting the Anti-Tippers
A 1
1
/
2
to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times.
If adjusting anti-tippers on recliner models, ensure back
canes are in the upright position before making
adjustments.
Release Buttons
1
1
/
2
to 2 inch Clearance