Filter
Top Products
8 REAR WHEELS
Part No 1110546 47 Invacare® Tracer™ EX2 Wheelchair
8.3 Adjusting Quick-Release Axle
1. Remove rear wheel and quick-release axle from the wheelchair. Refer to Removing/Installing Rear Wheels on page 44.
2. Depress detent pin in the quick-release axle and slide axle through
the rear wheel hub.
3. Release detent pin ensuring that the detent balls are fully released.
4. Increase or decrease end play by adjusting the locknut on the end
of the quick-release axle.
5. Reinstall rear wheel onto the wheelchair. Refer to Removing/
Installing Rear Wheels on page 44.
FIGURE3 Adjusting Quick-Release Axle
ƽ
WARNING
Make sure detent pin and detent balls of the quick-
release axles are fully released before operating
the wheelchair.
Keep detent balls clean.
Axle Spacer
(Conventional Arms Only)
Quick-Release
Axle
Detent Balls
Axle Bushing
Rear Wheel Hub
Detent Pin
Locknut