Filter
Top Products
5 FRONT RIGGINGS
Part No 1110546 31 Invacare® Tracer™ EX2 Wheelchair
5.2 Adjusting Footplate Height
Spring Button
1. Remove the front rigging assembly. Refer to Installing/Removing
Front Riggings on page 30.
2. Pull the cam lock lever up to unlocked position.
3. Push in the release buttons and reposition the footplate assembly
to the desired height.
4. Ensure that the release buttons fully protrude from holes on both
sides of the front rigging support.
5. Rotate cam lock lever down to locked position.
6. Repeat this procedure for the other footplate, if necessary.
7. Reinstall the swingaway front rigging assembly. Refer to Installing/
Removing Front Riggings on page 30.
FIGURE2 Adjusting Footplate Height - Spring Button
This procedure applies to the swingaway front riggings
and swingaway elevating legrest.
Lay the front rigging assembly on a flat surface to simplify
this procedure.
The elevating legrest has two sets of release buttons,
one set above the other. Each set will be visible one
at a time allowing finer footplate height adjustment.
Front Rigging Support
Release Button
Footplate Assembly
Cam Lock Lever
Adjustment
Holes
Swingaway footrest shown