Filter
Top Products
5 FRONT RIGGINGS
Invacare® Tracer™ EX2 Wheelchair 30 Part No 1110546
5 Front Riggings
5.1 Installing/Removing Front Riggings
Installing
1. Turn the front rigging assembly to the side.
2. Install the hinge plates on the front rigging assembly onto the hinge
pins on the wheelchair frame.
3. Push the front rigging assembly towards the inside of the wheelchair
until it locks into place.
4. Repeat this procedure for the other front rigging assembly.
5. To release the front rigging, push the front rigging release lever
inward, rotate front rigging outward.
Removing
1. Push the front rigging release lever inward.
2. Rotate swingaway front rigging assembly outward.
3. Lift the swingaway front rigging assembly off the hinge pins.
FIGURE1 Installing/Removing Front Riggings
ƽ
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur.
When performing STEP 3, it may be necessary to
pull release lever toward front of chair to assist the
front rigging to lock in place.
The footplate will be on the inside of the wheelchair
when locked in place.
Front Rigging
Release Lever
Front Rigging
Assembly
Footplate
Hinge
Plates
Hinge
Pins
Swingaway footrest shown