Filter
Top Products
7 SEAT AND BACK
Part No 1110546 39 Invacare® Tracer™ EX2 Wheelchair
7.3 Adjusting Seat Depth
1. Remove the existing seat upholstery from the wheelchair. Refer to page 38.
2. Remove the two plug buttons from the ends of the crossbraces that
are towards the front of the wheelchair.
3. Install the two seat extension tubes into the ends on the
crossbraces. Line up the rear mounting hole of the seat extension
tube with the second mounting hole from the end of the
crossbrace.
4. Install the two seat extension spacers onto the two seat extension
tubes.
5. Install the new seat upholstery onto the wheelchair. Make sure to
line up the mounting holes in the seat extension tubes and seat
extension spacers with the new seat upholstery. Refer to page 38.
6. Install plug buttons into the ends of the seat extension spacers.
FIGURE3 Adjusting Seat Depth
ƽ
WARNING
The seat depth, size/position of the front casters, size/position of the rear wheels, use of an anti-tipper model, as well as the
user condition directly relate to the stability of the wheelchair. Any change to one or any combination of the seven may
cause the wheelchair to decrease in stability. These adjustments MUST be performed by a qualified technician.
If adjusting the seat depth of the wheelchair, the seat upholstery MUST be changed as well.
The two plug buttons will be used in the ends of the
seat extensions.
Seat Upholstery
Crossbrace
Second Mounting
Hole from End
Rear Mounting Hole
Seat Extension Tube
Plug
Button
Seat Extension
Spacer
Phillips
Screws