Filter
Top Products
10 ANTI-TIPPERS/WHEEL LOCKS
Invacare® Tracer™ EX2 Wheelchair 52 Part No 1110546
Installing Anti-Tippers
1. Press the release buttons and insert the anti-tippers with the anti-tipper wheels pointing toward the ground/floor into the wheelchair frame
tubing.
2. Ensure that the release button of the anti-tipper fully protrudes out of the hole in the bottom of the wheelchair frame tubing.
3. Place the wheelchair on a flat surface.
4. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
5. If the distance between the bottom of anti-tipper wheels and the
ground/floor is not 1
1
/
2
to 2 inches, adjust anti-tippers. Refer to
Adjusting the Anti-Tippers on page 53.
FIGURE1 Installing Anti-Tippers
To ensure the correct model anti-tipper is used refer to chart below. Measurements for anti-tippers are approximate and are taken with
extension tube in bottom hole position.
ANTI-TIPPER (MEASUREMENTS IN INCHES)
MODEL SEAT-TO-FLOOR
HEIGHT
(IN INCHES)
LENGTH HEIGHT MODEL PART NO.
TRACER
EX2
17
1
/
2
to 19
1
/
2
13
1
/
2
3
1
/
2
1360 1058836
TRACER
EX2 FF
21 12
2
3
/
4
9758 1086190
Anti-Tipper
Length
Anti-Tipper Height
Flat Surface
Bottom
Position
A 1
1
/
2
to 2 inch clearance between the bottom of the
anti-tipper wheels and the ground/floor MUST be
maintained at all times.
Anti-Tipper
Wheels
Anti-Tipper
Release Buttons
Rear Frame Tubing
Anti-Rattle