Extron electronic DSC 301 HD Scale User Manual


  Open as PDF
of 44
 
Command ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
Overscan mode (applies only to SMPTE [NTSC, PAL, SECAM, 480p-1080p 50/60] input rates)
Set value
EX#*X2#OSCN} OscnX#*X2#]
Set input format X# to overscan mode
X2#.
View status
EX#OSCN}
X2#]
Show overscan mode status for input
format X#.
HDCP notification (green screen/message)
Enable notification
EN1HDCP} HdcpN1]
Enable the HDCP notification.
Disable notification
EN0HDCP} HdcpN0]
Disable the HDCP notification; instead
mute output.
Query notification
ENHDCP}
X(]
Query the HDCP notification.
HDCP status (valid for HDMI input and HDMI ouput only)
Query input
EIX!HDCP}
X2*]
HdcpIX!*X2*]
Query the HDCP status of the current
input
X!.
(verbose mode response)
Query output
EOX@HDCP}
X2*]
HdcpOX@*X2*]
Query the HDCP status of the HDMI
output
X@.
(verbose mode response)
HDCP input authorization (valid for HDMI input only)
Enable HDCP
encryption support
EEX!*1HDCP} HdcpEX!*1]
Enable HDCP encryption support for
input
X! (default).
Disable HDCP
encryption support
EEX!*0HDCP} HdcpEX!*0]
Disable HDCP encryption support for
input
X!.
Query encryption
support status
EEX!HDCP}
X4)]
Query HDCP encryption support status
for input
X!.
NOTE: X! = Input selection: 1 to 3
X@ = Output selection: 1 = HDMI
X# = Input video format:
1 = RGB
2 = YUV
3 = Composite
4 = HDMI
X( = Enable or disable: 0 = Off or disable, 1 = On or enable
X2# = Overscan (applied to SMPTE [NTSC, PAL, SECAM, 480p, 576p, 720p, 1080i, 1080p] input rates):
0 = 0.0% (default for RGB, HDMI) — a “true” Auto-Image will be executed on SMPTE inputs.
1 = 2.5% (default for YUV, composite) — an Auto-Image command snaps to a 2.5% table; no true Auto-Image.
2 = 5.0% — an Auto-Image command snaps to a 5.0% table; no true Auto-Image.
X2* = HDCP status (valid only on TMDS inputs or outputs):
0 = No sink or source detected
1 = Sink or source detected with HDCP
2 = Sink or source detected but no HDCP is present
X4) = HDMI input HDCP authorization status:
0 = Block HDCP encryption
1 = Allow HDCP encryption (default for input 3)
DSC 301 HD • SIS Communication and Control 34
 previous next