Filter
Top Products
Input Submenu
This submenu allows the user to configure the active input.
Figure 7. OSD Menu — Input Submenu
Auto-Image — Select this to start a one-time Auto-Image on the active input.
Input x: Input Format — Select this to change the active input format.
NOTE: Only input 2 can be changed (RGB or YUV). Input 1 is always composite
video and input 3 is always HDMI.
Input x: Film Mode — Select this to turn Film Mode on (auto detect mode) or off.
(Pixel) Start — Select this to adjust the horizontal and vertical pixel start (range is 0 to
+255, default is 128).
Active (pixels) — Select this to adjust the horizontal and vertical active pixels (range is
dependant on input).
Total Pixels and Phase — Select this to set the number of active pixels and the phase
value.
Input x: HDCP Authorized — Select this to turn the HDCP Authorized on (default) or off.
NOTE: Applicable to HDMI input 3 only.
When disabled (off) the DSC 301 HD will not display content that requires HDCP, and
displays ether a blank screen or a warning message from the input source.
Input x: EDID — Select this to change the EDID (resolution and refresh rate) for the active
input. Set to either match output rate, or a custom user-defined EDID, or a factory setting
(see table on page 18 for EDID data).
DSC 301 HD • Operation 12