Filter
Top Products
Instruction Manual
760008-A
September 2001
3-10 Operation Rosemount Analytical Inc. A Division of Emerson Process Management
Model NGA 2000 TO2
c. Multi Component Display
If other analyzer modules are connected
to the Platform, it is possible to display up
to five using the following steps to change
from the single component display to the
multi component display as follows:
Figure 3-12. Multi Component Display
From the single channel display (Measure)
press F1 (Display) to change to the Multi
Component Display of all other installed
Analyzer Modules.
Note: Changing to the multi component dis-
play can be done from each single compo-
nent display.
Each bargraph shows the start and end of
the range for the respective channel. The
number in parentheses indicates the number
of the selected range for that channel. (F.S. =
full scale)
Note: Display may look different depending
on installed analyzers.
Use the F3 key (Tags Off) to turn the ana-
lyzer tags on or off.
To select a single channel display in the multi
channel display, enable the select symbol (>)
by pressing the F1 key of the ↓ key.
Then use the ↓ or ↑ key to select the line for
the desired channel. When the desired chan-
nel is marked, select it for single component
display by pressing the F1 key.
Select
Status… Ta
g
s Off LCDReset
37.50
2.50
95.00
150.0
TO2
ppm O2
MLT/CH1
% CO2
MLT/CH2
ppm CO
MLTCH3
Ppm NO
0.00
[
3
]
50.00
0.000
[
2
]
5.00
0.00
[
2
]
250.00
>
TO2
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 3 50.00
37.50
ppm O2
Electrolyte level: OK
Temp current: 263 uA 0.0 600
Range: 3
Sensor Current: 0.0500 uA 0.0000 100.0000
MLT/CH1/R2
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 2 5.00
2.50 % CO
2
Temperature: 37.0 C 0.0
Maintenance-Requests: No
Any-alarms: No
Operation: Ready
0.00
[
2
]
F.S. 150.00