Filter
Top Products
Instruction Manual
760008-A
September 2001
Rosemount Analytical Inc. A Division of Emerson Process Management Operation 3-9
Model NGA 2000 TO2
b. Single Component Display
The Measure menu that displays after
startup is the Single Component display
of the analyzer. If other analyzer modules
are connected to the Platform, it is possi-
ble to display them using the following
steps to change the channel of the single
component display:
Figure 3-11. Single Component Display
Press F4 (Channel) to change to the Single
Component Display of any other installed
Analyzer Modules.
Example:
Changing from TO2 (channel 1) to CO
2
(channel 2).
Note: Display may look different depending
on installed analyzers.
Continue pressing F4 to display the desired
channel depending on the installed analyzer
configuration, ultimately returning to the first
channel.
Single component display of the starting
channel.
TO2
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 3 50.00
37.50
ppm O2
Electrolyte level: OK
Temp current: 263 uA 0.0 600
Range: 3
Sensor Current: 0.0500 uA 0.0000 100.0000
MLT/CH1/R2
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 2 5.00
2.50 % CO
2
Temperature: 37.0 C 0.0
Maintenance-Requests: No
Any-alarms: No
Operation: Ready
TO2
Dis
p
la
y
Status… Main… Channel BasicCal
0.00 Ran
g
e: 3 50.00
37.50
ppm O2
Electrolyte level: OK
Temp current: 263 uA 0 600
Range: 3
Sensor Current: 0.0500 uA 0.0000 100.0000