Filter
Top Products
Instruction Manual
IM-106-4050 Original Issue
March 2006
OxyBalance Oxygen Display
and Averaging System
http://www.processanalytic.com
Section 2 Installation
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-1
System Considerations . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-1
Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-2
Wiring Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-2
Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-2
OVERVIEW This section describes:
1. Wall-mounting of the OxyBalance system.
2. The necessary wiring schematics for proper connection of the
OxyBalance system.
3. Setup procedures conducted through the PanelView Plus 600 on how to
configure, assign nomenclature, change/update display settings, and
assigning the O
2
probes to the average outputs.
SYSTEM
CONSIDERATIONS
Prior to installation of the OxyBalance system, check for all components
necessary to install the system completely. When selecting a mounting
location, determine where the OxyBalance system will be placed in terms of
serviceability, ambient temperatures, environmental considerations, and
convenience.
Before starting to install this equipment, read the "Safety Instructions" in Appendix A: Safety
Data. Failure to follow the safety instructions could result in serious injury or death.
Disconnect all power before installing or replacing components. Failure to disconnect power
may result in electrical shock and/or damage to the terminal.
Install all protective equipment covers and safety ground leads after installation. Failure to
secure covers and ground leads could result in serious injury or death.