639
Occupied Bandwidth Measurement
Sweep/Control
Example: OBW:SWE:POIN 1500
OBW:SWE:POIN?
Notes: This function is not available when signal identification is set to On (external
mixing).
Affected by:
log sweep
Grayed out in measurements that don’t support swept
Blanked in modes that do not support swept.
Whenever the number of sweep points change:
- All trace data is erased
- Any traces with Update Off also go to Display Off (like going from View to
Blank in the older analyzers)
- Sweep time is re-quantized
- Any limit lines that are on are updated
- If averaging/hold is on, averaging/hold starts over
Couplings: Whenever the number of sweep points change, the sweep time is re-quantized.
Preset: LTE, LTETDD: 2001
Other: 1001
State Saved: Saved in instrument state.
Min: 101
Max: 20001
Initial S/W Revision: Prior to A.02.00
Modified at S/W Revision: A.03.00
