311
6 Channel Power Measurement
The Channel Power measurement is used to find the total power present in a specified bandwidth. The
power spectral density (the power in the signal normalized to 1 Hz) is also reported (In WLAN mode, the
peak power spectral density for 1 MHz is reported). For measurement results and views, see
“View/Display” on page 369.
This topic contains the following sections:
“Measurement Commands for Channel Power” on page 311
“Remote CommandResults for Channel Power Measurement” on page 312
Measurement Commands for Channel Power
These commands are used to measure the total rms power in a specified integration bandwidth.
Use :INSTrument:SELect to set the mode.
:CONFigure:CHPower
:CONFigure:CHPower:NDEFault
:INITiate:CHPower
:FETCh:CHPower[n]?
:MEASure:CHPower[n]?
:READ:CHPower[n]?
:FETCh:CHPower:CHPower?
:MEASure:CHPower:CHPower?
:READ:CHPower:CHPower?
:FETCh:CHPower:DENSity?
:MEASure:CHPower:DENSity?
:READ:CHPower:DENSity
For more measurement related commands, see the SENSe subsystem, and the section “Remote
Measurement Functions” on page 1031.
