Teledyne 100EU Blood Glucose Meter User Manual


 
M100EU – OPERATIONS MANUAL TELEDYNE INSTRUMENTS
Addendum to M100E Manual - P/N 04515 SPECIFICATIONS, APPROVALS AND WARRANTY
05944 Rev
B 5
DCN 5063 PRINTED DOCUMENTS ARE UNCONTROLLED
2. SPECIFICATIONS, APPROVALS AND
WARRANTY
2.1 SPECIFICATIONS
Table 2-1: Model 100EU Basic Unit Specifications
Min/Max Range
(Physical Analog Output)
In 1ppb increments from 50ppb to 20 000ppb, dual ranges or auto ranging
Measurement Units ppb, ppm, µg/m3, mg/m3 (user selectable)
Zero Noise
2
25 ppt RMS (50 ppt RMS with 360 nM filter installed)
Span Noise
2
0.5% of reading RMS, above 5 ppb
Lower Detectable Limit
3
50 ppt RMS
Zero Drift (24 hours) <200 ppt (<400 ppt with 360 nM filter installed)
Zero Drift (7 days) <200 ppt (<400 ppt with 360 nM filter installed)
Span Drift (7 Days) <0.5% FS
Linearity 1% of full scale
Precision 0.5% of reading
Temperature Coefficient < 0.1% per
o
C
Lag Time
1
30 sec
Rise/Fall Time
1
95% in <140 sec
Sample Flow Rate 650cc/min. ±10%
Temperature Range 5-40oC
Humidity Range 0 - 95% RH, non-condensing
Dimensions H x W x D 7" x 17" x 23.5" (178 mm x 432 mm x 597 mm)
Weight, Analyzer
(Basic Configuration)
45 lbs (20.5 kg) w/internal pump
AC Power Rating
100 V, 50/60 Hz (3.25A); 115 V, 60 Hz (3.0 A);
220 – 240 V, 5
0/60 Hz (2.5 A)
Environmental Installation category (over-voltage category) II; Pollution degree 2
Analog Outputs Three (3) Outputs
Analog Output Ranges
100 mV, 1 V, 5 V, 10 V, 2-20 or 4-20 mA isol
ated current loop.
All Ranges with 5% Under/Over Range
Analog Output Resolution 1 part in 4096 of selected full-scale voltage
Status Outputs 8 Status outputs from opto-isolators
Control Inputs 6 Control Inputs, 3 defined, 3 spare
Serial I/O
One (1) RS-232; One (1) RS-485 (2 connecters in parallel)
Baud Ra
te : 300 – 115200: Optional Ethernet Interface
Certifications
EN61326 (1997 w/A1: 98) Class A, FCC Part 15 Subpart B Section 15.107 Class
A, ICES-003 Class A (ANSI C63.4 19
92) & AS/NZS 3548 (w/A1 & A2; 97)
Class A.
IEC 61010-1:90 + A1:92 + A2:95,
1-As defined by the USEPA; 2 – 25 samples taken, 10 sec. interval; 3 – Twice zero noise